This was a project for a client in Albuquerque, New Mexico named John Mitchell. I was contracted to build this set of 2 custom built-in scuppers as seen below and provide him with copper downspouts:

One diagram, out of several:

I was also asked to build these decorative fascia boards covered in a white pained aluminum sheet metal. I cut and layered 3/4" Birch plywood in this decorative pattern. We did about $1,786 worth of work in aluminum and copper for the entryway of his house. Here are the photos I sent this client through e-mail as I progressed:

This is the wall cap metal:

Then I had to figure out how to safely transport these down to New Mexico.

Here is a few shots the client sent me of the installation:

(a) Gutter Installation
(b) Gutter Debris Protection Options
(c) Roofing Quality Standards
(d) Chimney Flashing
(e) Moss Control & Treatment

web pages for answers and solutions that could save you thousands of $ and a great deal of anguish.

If you do find this information very helpful, feel free to send us a $ tip for the assistance we so freely have published on the web here for your benefit, like you might tip a waitress.  Heck, send us a gift certificate for a candle lit dinner for two.