Note: remember that you can click on each picture shown to get a closer look

This set of 2 decorative diverter trays I made out of a thicker 48oz copper to hold a set of rain-cups without the need for a wood support underneath. They were ordered through SYMBIOS, a contractor in Occidental, California for their client. They made this cardboard full size model and sent it to me to work from, so it would be sure to fit just right.  The total for these two custom scuppers was $450 with shipping. Here is some photos they sent me when they first wrote to me:

Here is a few shots I sent them during the fabrication process:

I advised to leave the end open to cause less of an obstruction for debris. I added this support pipe to the end to hold the copper rain-cups. I made these as seamless as possible with the wings soldered on. I included some stainless steel screws and copper roofing nails for a firm attachment. I predrilled the holes in the wings for the screw placements.